SMT Rework Station

Model: 
SD-3000II

This rework system is designed to remove most SMT components like QFPs, SOPs, PLCCs SOJs, PGAs, BGAs, Connectors and other chips. It does not require any special nozzles or additional accessories. Built in timer to prevent overheating of board and component. The hot air nozzle has an adjustable motion range of up to 50mm per axis.

Catalog: 
application/pdf icondenon_sd-3000ii.pdf 870.29 KB
Features: 
  • Can handle most SMT parts of up to 50mm square without requiring different nozzles.
  • Can remove SMT connectors by setting a single axis motion.
  • The built in timer enables to prevent damage of PCB and near by parts caused by over heating.
  • Anybody can use this system without difficulty doe to the simplified programming.
  • Compact and light weight.
  • Low cost, highly efficient.
  • Can rework the micro components like 0603

Accessories

  • Vacuum Pick (Tweezer)
  • 3 Suction Pads (Cups) for Vacuum Pick (Tweezer)
  • 5 Filters for Vacuum Pick (Tweezer)
  • Base Plate with 430mm x 300mm
  • 2 for PCB Holder Small (P/#H-1)
    2 for PCB Holder Large (P/#H-2)
  • Base Plate Stand (P/#S-1)
  • PCB Support Pin (P/#H-3)
  • Metal Frame (P/#20-10-10)

Options

  • Monitor & Camera to Assist in rework of Micro Components
  • Auxiliary Holder for Small Boards
  • SMT PIN for Rework of Micro Components
General specifications: 
Heating Method HOT AIR NOZZLE -4mm, 350 Watts
Airflow Rate 1.5L - 12L/min in 8 Steps
Air Pump and Vacuum Internal, Does not Require Shop Air
Nozzle Motion Range Maximum X and Y Motion=50mm, Z=25mm
Temperature Control Analog with Digital Readout for 260 to 600 Degrees C
Timer Control Analog with Digital Readout for 5 - 500 seconds
Max.PCB Size Throat Depth=420mm, Width=Any Size
Power Consumption 100,120, or 230VAC, 350 Watts
Dimensions 300mmW x 310mmHx 450mm D
Weight 9kg